Login:
Votes - 12, Average rating: 3.5 ( )

User manual Vitek, model VT-3549 SR

Manafacture: Vitek
File size: 1.84 mb
File name: Vitek-VT-3549_SR-Pdf-Rus.Pdf
Language of manual:ruukende
Free link for this manual available at the bottom of the page



manual abstract


Or you can remove the stand and mount the unit on a wall using the recessed screw hole. GETTING STARTED 1. SETTING UP THE BAROMETER a. When batteries are installed, the display will shows the “hPa”, “mBar” and “mmHg”. User should press the “Unit” key to the unit of pressure, it will shows “0” and “meter”. User can use the “Up” or “Down” keys to change to “feet”, or use the “Unit” key to confirm the unit. b. After user confirmed the unit of height, it will shows “10” with “meter” or “32” with “feet”. User can use the “Up” or “Down” keys to change to height of the place, and use the “Unit” key to confirm the height. Remark: The default unit of pressure is hPa/mBar, unit of height is meter, height is 10 meters. It will use the default value if no key is pressure for 60 seconds. 2. SETTING UP THE REMOTE TEMP. AND RC CLOCK a. Once batteries are in place for the remote unit, they will start transmitting temperature and humidity readings at 5 •9.indd 5 02.06.2006 16:59:36 ENGLISH around 45 seconds intervals. The main unit will also start searching for signals for about two minutes once batteries are installed. 10 seconds upon successful reception, the outdoors temperatures and humidity will be displayed .The main unit will automatically update its readings at about 45-second intervals. b. If no signals are received, blanks “--.-” will be displayed. Hold [-] for 2 seconds to enforce another search for about 2 minutes. This is useful in synchronizing the transmission and reception of the remote and main units. c. When remote signal reception is finished, it will automatically synchronize its current time and dated when brought within rang of the signal. Repeat this step whenever you find discrepancies between the reading shown on the main unit and that on the remote unit. HOW TO CHECK REMOTE AND INDOOR TEMPERATURES The wave display on the outdoors temperature indicates the reception of the remote unit is in good order. If no readings are received from the remote unit for more than two minutes, blanks “--.-” will be displayed until further readings are successfully searched. Check the remote unit is sound and secure. You can wait for a little while or Hold [-] for 2 seconds to enforce an immediate search. If the temperature or humidity goes above or below than the measuring range of the main unit or the remote unit (stated in specification), the display will show “--.-” & “HHH” or “LLL” respectively. HOW TO READ THE KINETIC WAVE DISPLAY The kinetic wave display shows the signal receiving status of the main unit. There are three possible forms: The unit is in searching mode. • • Temperature readings are securely registered. No signals. 0 0 l 1 ' 1 MAXIMUM AND MINIMUM TEMPERATURES AND HUMIDITY The maximum and minimum recorded indoor temperature, humidity and outdoor temperatures will be automatically stored in memory. To display them, Press [MEM] once to display the maximum readings and again the minimum readings. The respective indicators [MAX] or [ MIN ] will be displayed. To clear the memory, hold down [MEM] for two seconds. The maximum and minimum readings will be erased. 6 •9.indd 6 02.06.2006 16:59:36 ENGLISH If you press [MEM] now, the maximum and minimum readings will have the same values as the current ones until different readings are recorded. TEMPERATURE AND HUMIDITY TREND The trend indicator shows the trend of temperatures and humidity collected at that particular remote sight. Three trends: rising, steady, and falling will be shown. Arrow indicator 3 a a Temperature and humidity trend Rising Steady Falling WEATHER FORECAST Indicator displays on 0


Reviews



Your review
Your name:
Please, enter two numbers from picture:
capcha





Category