Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

Thermo Products CHX1-75

downloaded: 0File size: 1 mb    Manafacture: Thermo Products  
Category: Electric Heaters

: If you suspect there is a problem with the furnace, its venting system or any other related problem, immediately contact a qualified service agency. 11. Your furnace should be described by the model number and serial number when contacting a qualified heating contractor. This important information is located on the rating plate behind the front door. 12. Should this unit be installed in an attic or other insulated area or if the area is insulated after the furnace is installed, the furnace mus

Thermo Products CHX1-125N

downloaded: 2File size: 2 mb    Manafacture: Thermo Products  
Category: Electric Heaters

If any of the original factory supplied furnace wiring is replaced or a separate device other than the thermostat is wired internal to the unit 105°C thermoplastic or equivalent wire must be used. 28 All installations and services must be performed by qualified service personnel. IV. STARTING THE UNIT A. SEQUENCE OF OPERATIONS AT ANY TIME THE GAS VALVE IS NOT ENERGIZED CONTINUOUS SAFE OPERATION CHECK IF FLAME SIMULATION CONDITION PRESENT OR ROLL-OUT SWITCH OPENS, SYSTEM ENERGIZES INDUCER FAN FOR

Thermo Products CHX1-125

downloaded: 0File size: 1 mb    Manafacture: Thermo Products  
Category: Electric Heaters

7. No attempt should be made to restart the unit in the event that gas to the main burner has been shut off. Contact a qualified heating contractor before restarting the furnace. All installations and services must be performed by qualified service personnel. 8. The furnace should be inspected annually by a qualified heating contractor. 9. : Do not use this furnace if any part has been under water. Immediately call a qualified heating contractor to inspect the furnace and to replace any part of

Thermo Products CHX1-100N

downloaded: 0File size: 2 mb    Manafacture: Thermo Products  
Category: Electric Heaters

clear tubing) to the other side of the condensate trap tee. On CHX1/CDX1’s, this hose is shipped in the parts package and it will be necessary to attach the other end to the PVC drain tee assembly (see Figure 15). Use the silver clamp(s) provided in the parts package to secure all connections. 5. Install field supplied 1/2” CPVC drain pipe and elbows using CPVC cement to reach a nearby drain. A minimum 1/4” per foot downward slope toward the drain must be maintained. The drain line must be water

Thermo Products CHX1-100

downloaded: 0File size: 1 mb    Manafacture: Thermo Products  
Category: Electric Heaters

Go to the next step if you don’t smell gas. 7. Turn gas control knob counterclockwise to “ON” position. (For gas valves with a switch, move the switch to the “ON” position). 8. Replace front door. 9. Turn on electric power to the appliance. 10. Set thermostat to desired setting. 11. Follow the instructions “To Turn Off Gas To Appliance” and call a qualified heating contractor or gas supplier if the appliance will not operate. C. SHUTDOWN PROCEDURE TO TURN OFF GAS TO FURNACE: 1. Set the thermosta

Thermo Products CHB1-75

downloaded: 0File size: 1 mb    Manafacture: Thermo Products  
Category: Electric Heaters

DO NOT STORE OR USE GASOLINE OR OTHER FLAMMABLE VAPORS AND LIQUIDS IN THE VICINITY OF THIS OR ANY OTHER APPLIANCE. WHAT TO DO IF YOU SMELL GAS: • DO NOT TRY TO LIGHT ANY APPLIANCE. • DO NOT TOUCH ANY ELECTRICAL SWITCH; DO NOT USE ANY PHONE IN YOUR BUILDING. • LEAVE THE BUILDING IMMEDIATELY. • IMMEDIATELY CALL YOUR GAS SUPPLIER FROM A NEIGHBOR’S PHONE. FOLLOW THE GAS SUPPLIER’S INSTRUCTIONS. • IF YOU CANNOT REACH YOUR GAS SUPPLIER; CALL THE FIRE DEPARTMENT. INSTALLATION AND SERVICE MUST BE PERFOR

Thermo Products CHB1-50

downloaded: 0File size: 1 mb    Manafacture: Thermo Products  
Category: Electric Heaters

10. Should overheating occur or the gas supply fail to shut off, shut off the manual gas valve to the furnace before shutting off the electrical supply. : If you suspect there is a problem with the furnace, its venting system or any other related problem, immediately contact a qualified service agency. 11. Your furnace should be described by the model number and serial number when contacting a qualified heating contractor. This important information is located on the rating plate behind the fron

Thermo Products CHB1-125

downloaded: 0File size: 1 mb    Manafacture: Thermo Products  
Category: Electric Heaters

Make sure that horizontal runs of vent pipe slope upward towards the outside. The inlet pipe should slope slightly downward to prevent condensate build up. Any signs of damage, leakage, deterioration, or possible blockage should be immediately reported to your dealer or the local gas company. It is recommended that the condensate removal system be cleaned annually by a qualified service agency to insure its proper and continued operation. Outside vent and outside combustion air termination: the

Thermo Products CHB1-100

downloaded: 1File size: 1 mb    Manafacture: Thermo Products  
Category: Electric Heaters

: Shut off the power to the furnace before removing blower compartment door to avoid injury from moving parts. A. ANNUAL INSPECTION The homeowner must have this furnace professionally inspected at the beginning of each heating season by a qualified heating contractor to ensure proper operation. 11 All installations and services must be performed by qualified service personnel. NOTICE: This furnace has been shipped from the factory with a permanently lubricated circulating air blower motor. Any m

Thermo Products CDX1-75N

downloaded: 1File size: 2 mb    Manafacture: Thermo Products  
Category: Electric Heaters

: This furnace is not to be used for temporary heating of buildings or structures under construction. Many of the chemicals used during construction, when burned, form acid bearing condensate that can substantially reduce the life of the heat exchanger. A. CODES AND CLEARANCES The following items must be considered when choosing the size and location of the furnace. 1. All local codes and/or regulations take precedence over the instructions in this manual and should be followed accordingly. In t





Category