Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

Alpha Industries 700

downloaded: 0File size: 1023 kb    Manafacture: Alpha Industries  
Category: Power Supply

Only qualified personnel should change them. Procedure WARNING: Do not replace the batteries when the ON-BATT LED is on. 1 Enable the manual bypass (Section 3.4). 2 Pop off and remove the front cover.. 3 Unscrew and remove the battery cover. 4 Remove the battery cartridge from the unit. Take note of the battery configuration and wiring. 5 Replace the batteries with any of the qualified batteries listed in Figure 3.4. 6 Push the cartridge with the new batteries back into the unit. 7 Reinstall the

Alpha Industries 3000

downloaded: 0File size: 1023 kb    Manafacture: Alpha Industries  
Category: Power Supply

The first parameter, “O/P Volt Set” is displayed on the LCD (Figure 3.1). 2 Press FUNC to scroll through the parameters until “Battery Test” appears. 3 Press the ENTER button. When the LCD shows “Test?” press ENTER. The test starts and the LCD shows “Battery Test.” 4 After the test, the unit resumes line mode and the LCD shows “Line Mode.” If a fault is found, the FAULT LED is on. Do troubleshooting as described in Section 3.5. Self Test Finished 3.4 Changing the Parameters You can change the un

Alpha Industries 2000

downloaded: 0File size: 1023 kb    Manafacture: Alpha Industries  
Category: Power Supply

2.2 Wiring the Unit Procedure: 1 Connect the load(s) to the unit.s output connector(s) (Figure 2.1). 2 Connect RS.232 or other communications, emergency power off switch, battery packs or any other options (Sections 2.3 to 2.6). 3 Connect the line to the unit.s input connector. TIP: Determine what output voltage you are using. When starting the unit for the first time, see if you need to configure the unit.s output voltage (Section 3.4). Wiring Finished Turn on the unit as described in Section 3

Alpha Industries 1500

downloaded: 2File size: 1023 kb    Manafacture: Alpha Industries  
Category: Power Supply

When line power is requalified, the Pinnacle automatically restarts, providing power to the loads and recharging the batteries. • RS.232 Communication The Pinnacle Plus series can be remotely monitored and controlled. • LCD/LED Display Panel The LCD/LED display provides .at-a-glance. monitoring. • Battery Charge Display The LCD shows the battery % charge, battery backup time and battery voltage. • Load Display The LCD shows the unit.s % loading and the loading in watts and VA. • Automatic Bypass

Alpha Industries 1000

downloaded: 3File size: 1023 kb    Manafacture: Alpha Industries  
Category: Power Supply

Keep it in a safe place. CAUTION Risk Of Electrical Shock To reduce the risk of electrical shock and to ensure the safe operation of the Pinnacle Plus Series of UPS.s, these symbols are used throughout this manual. Where they appear only qualified personnel should carry out the instructions. A DANGEROUS VOLTAGE exists in this area. Use extreme caution. ATTENTION: Important operating instructions. Follow them exactly. NOTICE: The Pinnacle Plus Series generates, uses and can radiate radio frequenc





Category