Harsh abrasive cleaners (Ajax, Comet, etc.) may dull the finish. You need not worry about rust, as the metal parts are stainless steel. Columbia Medical 13577 Larwin Circle Santa Fe Springs, CA 90670 (310) 454-6612, Fax: (310) 305-1718 Email: firstname.lastname@example.org Visit us at © 2006 Columbia Medical Mfg LLC Text Box: Angles of adjustment: * +/-3° • Back to Seat Angles* - 0°, 30°, 60°, 90° • Leg to Seat Angles* - 0°, -30°, -60° *Do not use -90° position. Text Box: Maximum Weight Capacity DO NO
The legs, calf support and back angles each adjust independently. Adjustments to the Ultima should not be made while in use. Adjusting Back Angle: Locate the adjustment lever bar on the Chair’s back, under the cover (you do not need to remove the cover to operate the lever), and simply grip the lever and seat frame back and squeeze together. Then, with a lifting motion, adjust the back angle up or down. Adjusting Calf Support Angle: Locate the adjustment lever bar on the Chair’s calf support, un
Press Stainless Steel Caps over the Pull Handle's small end that will now be protruding from the pull-tab. 4. Pull the Pull Handles until Back Support and Calf Support are pointing straight up. 5. Slip the Bath Chair Cover over the Back Support, making sure the Pull handles are under the cover. 6. Place chair in are horizontal position, then turn chair upside down and fasten Velcro strap. Setting the Angle of the Contour Ultima Bath Chair The Contour Ultima is easy to adjust using the four simpl
Please take the time to read these assembly instructions and pay particular attention to the safety information provided. Thank you again for choosing Columbia! Important Safety Instructions When using your bath chair, always take basic safety precautions to reduce the risk of injury to persons. 1. Read and understand all instructions. 2. Determine, with a physician or therapist, the suitability of this product for the intended user. 3. To reduce the risk of injury or drowning, never leave the u
STEP 5: Head Pads and Lateral Positioning Pads The head pads may be adjusted for height. Located behind, and underneath each head pad is a plastic ball, attached to the lace that passes through the head pad. Squeeze the button on each ball and slide the ball up or down to change the height of the head pads. Lateral Positioning Pads: If the occupant is slender or small, the car seat may be too wide. You can narrow the inside seat width with this Lateral Positioning Pad Set. Use only as many pads
WARNING! DEATH OR SERIOUS INJURY CAN OCCUR: • Model #2000 is for use only with individuals who weight between 20 - 102 lbs (9.09 - 46.36 kg) and whose shoulder height when sitting is 12 -20 in. • Model #2500 is for use only with individuals who weight between 50 - 130 lbs (29.5 - 59 kg) and whose shoulder height when sitting is 13 -24 in. • Model #2500 - Do not use with individuals under 65 lbs (29.5 kg). • Failure to follow each of the following instructions can result in your child striking th
This equipment generates, uses and can radiate radio frequency energy and, installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of t
Safety • Setup • Adjustments • Operation • Maintenance • Troubleshooting • Parts Lists • Warranty LES DISTRIBUTIONS RVI LIMITEE, 2955, JEAN-BAPTISTE DESCHAMPS, LACHINE, QUEBEC H8T 1C5 21” Rotary Mower — Model Series 540 11/26/07 769-02853A This Operator’s Manual is an important part of your new equipment. It will help you assemble, prepare and maintain the unit for best performance. Please read and understand what it says. Table of Contents Slope Gauge............................................