Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

Design Dynamics VTD-30N-JHB

downloaded: 0File size: 678 kb    Manafacture: Design Dynamics  
Category: Gas Heaters

CURING Logs During the 2-3 hour appliance break in period, you may detect an odor from appliance as the various paints and compounds used in the manufacturing of this log set cure. This is a normal and temporary situation that is not cause for alarm. However, you may want to provide extra ventilation to the room during this time. To ensure proper curing of logs: • Ignite a 2" flame and maintain for 1 hour • Burn logs in consecutive 1 hour periods raising flame an additional 2" to full height for

Design Dynamics VTD-24N-JHB

downloaded: 0File size: 678 kb    Manafacture: Design Dynamics  
Category: Gas Heaters

The charts in Figure 2, page 6 indicate technical information regarding the installation of your gas log set. Please make sure that all of the specifications shown are applicable before installation is attempted. The fireplace must include a flue and venting system with the minimum openings shown in Figure 2, page 6. Log Set Assembly Grate Ceramic Burner Chassis Figure 1 - Product Identification (Ramp Pan Burner) Installation Continued Model Burner DESCRIPTION Btu Input Minimum Vent Opening VTD-

Design Dynamics VTD-18N-PDG

downloaded: 0File size: 1 mb    Manafacture: Design Dynamics  
Category: Gas Heaters

Note: If pilot goes out, repeat steps 4 through 8. 9. Slightly push in and turn control knob counterclockwise to the ON position. 10. Wait one minute and switch selector switch to the ON position to light burners. 11. Set flame adjustment knob to any level between HI and LO. CAUTION: Do not try to adjust heating levels by using the equipment shutoff valve. Operating Heater Continued Control Knob Selector Switch LOIHOFFPILOTONAUTOOFFON Flame Adjustment Knob Ignitor Button Figure 11 - Control Knob

Design Dynamics VTD-18N-JHB

downloaded: 2File size: 678 kb    Manafacture: Design Dynamics  
Category: Gas Heaters

See warranty for additional information. WARNING: If the information in this manual is not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. — Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from

Design Dynamics HKE-24-RFP

downloaded: 0File size: 2 mb    Manafacture: Design Dynamics  
Category: Other Tools

Fits opening 28" to 4" wide. DAMPER CLAMP - GA6080 (Not Shown) Permanently opens chimney flue damper for vented operation. LAVA ROCK - GA6060 (Not Shown) Order when additional rock is desired (1.8 lb. bag) 115481-01B NOTES 115481-01B WARRANTY INFORMATION KEEP THIS WARRANTY Model Serial No. Date Purchased Always specify model and serial numbers when communicating with the factory. We reserve the right to amend these specifications at any time without notice. The only warranty applicable is our st

Design Dynamics HKE-24-RFN

downloaded: 0File size: 2 mb    Manafacture: Design Dynamics  
Category: Other Tools

— Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. — WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediatelycallyourgassupplierfromaneighbor’s phone. Follow the gas supplier’s instructions. • If you cannot reach your gas supplier, call the fire department. — Installation and service must be performed by a qualified installer, servic

Design Dynamics HKE-18-RFP

downloaded: 0File size: 2 mb    Manafacture: Design Dynamics  
Category: Other Tools

3 Replace thermopiles. 2 Devicetoohot.Turnonfan orifapplicable,openglass doors. 1 short blink Normal operation LED Failure Codes and Service Action WARNING:Turnoffandunplugheaterandletcoolbeforeservicing. Only a qualified service person should service and repair heater. IMPORTANT: Valve system troubleshooting should only be accomplished by a qualified service technician. Note: Before troubleshooting the gas control system, be sure external gas shut off valve (located at gas supply inlet) is in t

Design Dynamics HKE-18-RFN

downloaded: 0File size: 2 mb    Manafacture: Design Dynamics  
Category: Other Tools

CAUTION: You must keep control areas, burners and circulating air passageways of fireplace clean. Inspect these areas of fireplace before each use.Havefireplaceandchimney (if applicable) inspected yearly by a qualified service person. Fireplace may need more frequent cleaningdue to excessive lint from carpeting, bedding material, etc. Only limited cleaning will be required under normal use of this appliance. Dust the front grate and top of receiver/valve. Do not use cleaning fluids to clean logs

Design Dynamics HCM-24-RFP

downloaded: 0File size: 2 mb    Manafacture: Design Dynamics  
Category: Other Tools

C. Use only your hand to push in or turn gas control knob. Never use tools. If the knob will not push in or turn by hand, do not try to repair it, call a qualified technician. Force or attempted repair may result in a fire. D. Do not use this appliance if any part has been under water. Immediately call a qualified service technician to inspect the appliance and to replace any part of the control system and any gas control which has been under water. LIGHTING INSTRUCTIONS NOTICE: During initial o

Design Dynamics HCM-24-RFN

downloaded: 0File size: 2 mb    Manafacture: Design Dynamics  
Category: Other Tools

The pressure should be checked with the unit burning and set to High. Replace test point plug or tighten test screw after pressure measurement ensuring no gas leaks. PLACEMENT OF FLOOR MEDIA WARNING: Do not add extra logs or ornaments such as pine cones or vermiculite. Using these added items can cause sooting. Use only the material included in the kits. WARNING: Do not place lava rock,embersorfiberlogpieceson logs or burners. This may cause sooting.Placefloormediamaterial only on the fireplace





Category