Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

New Buck Corporation MODEL FP-327-ZC

downloaded: 0File size: 1 mb    Manafacture: New Buck Corporation  
Category: Fireplaces

4. Open access panel door located at bottom front of the appliance. 5. Turn control knob clockwise to the full “OFF” position. When hooking up a Wall Thermostat to valve, remove the Jumper Bar. Do not remove the existing wires, simply add the wire from the Wall Thermostat to screws (one wire to each screw). 6. Wait five (5) minutes to clear out any gas. Then smell for gas, including near the floor. If you smell gas, STOP! Follow “B” in the safety informationon the previous page.If you don’t smel

New Buck Corporation FP-BR-10-ZC

downloaded: 1File size: 1 mb    Manafacture: New Buck Corporation  
Category: Fireplaces

Seal all joints between the black fireplace face and the wall covering with a heat-resistant material such as rock wool insulation or mortar. Be sure to use high temperature adhesive or mortar when anchoring brick, stone, or tile to the face of the fireplace. CLEARANCES To ensure a safe installation, the following must be carefully observed. 1. Sidewall Clearances: Clearances from the right or left side of the fireplace opening to any adjacent combustible wall should not be less than 7", facing

New Buck Corporation DV23ZC

downloaded: 2File size: 693 kb    Manafacture: New Buck Corporation  
Category: Fireplaces

-WHAT TO DO IF YOU SMELL GAS * Do not try to light any appliance. * Do not touch any electrical switch; do not use any phone in your building. * Immediately call your gas supplier from a neighbor's phone. Follow the gas supplier's instructions. * If you cannot reach the gas supplier, call the fire department. -Installation and service must be performed by a qualified installer, service agency, or the gas supplier. -Save this manual for future reference. New Buck Corporation Revised Aug/2008 P.O.

New Buck Corporation DV1000

downloaded: 0File size: 2 mb    Manafacture: New Buck Corporation  
Category: Fireplaces

Approved By: WARNING: If the information in these instructions are not followed exactly, a fire or explosion may result causing property damage, personal injury or loss of life. . Do not store or use gasoline or other flammable vapors and liquids in the vicinity of this or any other appliance. . WHAT TO DO IF YOU SMELL GAS • Do not try to light any appliance. • Do not touch any electrical switch; do not use any phone in your building. • Immediately call your gas supplier from a neighbor’s phone.

New Buck Corporation CR8T

downloaded: 0File size: 799 kb    Manafacture: New Buck Corporation  
Category: Fireplaces

-WHAT TO DO IF YOU SMELL GAS *Do not try to light any appliance. *Do not touch any electrical switch; do not use any phone in your building. *Immediately call your gas supplier from a neighbor’s phone. Follow the gas supplier’s instructions. *If you cannot reach the gas supplier, call the fire department. -Installation and service must be performed by a qualified installer, service agency or the gas supplier. -Save this manual for future reference. This is an unvented and vented gas-fired heater

New Buck Corporation 85

downloaded: 0File size: 574 kb    Manafacture: New Buck Corporation  
Category: Fireplaces

Push up until the face of the outside air duct contacts the underside of the floor of the mobile home. For certain floor thickness, you may have to shorten the length of the outside air duct. 15. Secure the outside air duct to the floor using the four (4) #10 x 1" screws provided. See Figure 12. 26 RAIN CAP RAIN CAP Ceiling Exit (Using Close Clearance Listed Chimney) 1. Suspend a plumb bob from the ceiling above the unit so that the weight is hanging in the center of the flue exit. ( A sma

New Buck Corporation 81

downloaded: 2File size: 502 kb    Manafacture: New Buck Corporation  
Category: Fireplaces

(A small weight on a string will serve as a plumb bob.) Mark the ceiling where the string is suspended to locate the center of the chimney. 2. After locating the center of the hole, install the ceiling support box, chimney, flashing and rain cap per the chimney manufacturer's instructions. 3. Now connect the stove and ceiling support box using #24 ga. minimum blued or black steel connector pipe. (DO NOT USE GALVANIZED PIPE.) Connect each section so the crimped end faces downward, and secure ea

New Buck Corporation 74

downloaded: 0File size: 931 kb    Manafacture: New Buck Corporation  
Category: Fireplaces

CONTACT LOCAL BUILDING OR FIRE OFFICIALS CONCERNING RESTRICTIONS AND INSTALLATION INSPECTIONS IN YOUR AREA. TESTED AND LISTED BY: ITS/WARNOCK HERSEY, MIDDLETON, WI MANUFACTURED BY NEW BUCK CORPORATION - SPRUCE PINE, NC 28777 5/2007 BUCKSTOVE BUCKSTOVE TABLE OF CONTENTS Important Instructions......................................................................................................... 2 SECTION I: Introduction ............................................................................

New Buck Corporation 42ZCBB

downloaded: 0File size: 981 kb    Manafacture: New Buck Corporation  
Category: Fireplaces

CONSUMER: Retain this manual for future reference. New Buck Corporation P.O. Box 69 8000 Hwy. 226 South Spruce Pine, NC 28777 Revised: November 2004 TABLE OF CONTENTS Safety Information and Warnings.......................................................................................3 Installation...........................................................................................................................5 Firebox and Framing Dimensions (ZC) (FF)..............................

New Buck Corporation 42

downloaded: 2File size: 2 mb    Manafacture: New Buck Corporation  
Category: Fireplaces

Rooms communicating directly with the space in which the appliances are installed, through openings not furnished with doors, are considered a part of the unconfined space. “WARNING: IF THE AREA IN WHICH THE HEATER MAY BE OPERATED IS SMALLER THAN THAT DEFINED AS AN UNCONFINED SPACE OR IF THE BUILDING IS OF UNUSUALLY TIGHT CONSTRUCTION, PROVIDE ADEQUATE COMBUSTION AND VENTILATION AIR BY ONE OF THE METHODS DESCRIBED IN THE NATIONAL FUEL GAS CODE, ANSI Z223.1/ NFPA 54, SECTION 5.3 OR APPLICABLE LOC





Category