Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

Schneider Electric 560125R/2

downloaded: 0File size: 1 mb    Manafacture: Schneider Electric  
Category: Car Amplifiers

Refer to Figure 6. 2. Install the supplied ferrite filter on the power supply cable between the power supply and the MRA amplifier. The filter halves latch when closed over the cable. 3. After you have connected the C-Bus cable, loudspeakers and audio input, connect the power supply to a suitable wall power outlet. Refer to the appropriate sections in this document. Figure 6. MRA Amplifier External Power connections Note on Figure 6 The IR Target connectors on the amplifiers' rear panels are use

Schneider Electric 560125D/2

downloaded: 0File size: 1 mb    Manafacture: Schneider Electric  
Category: Car Amplifiers

Pre-wire Install the C-Bus network, speakers and audio source cabling. If you are connecting two or more amplifiers, install Digital Audio cables as well. Install the physical units Install the amplifier, speakers and power supply. Then connect the required cables. Apply power Check all wiring and plug the power supply in to the wall power outlet. Table 3. Installation steps Multi Room Audio Amplifier Installation Instructions 2.2 Equipment Placement When installing the amplifier and its speaker

Schneider Electric 560110R

downloaded: 8File size: 1 mb    Manafacture: Schneider Electric  
Category: Car Amplifiers

However, it assumes no responsibility for any loss incurred as a result of its use. Schneider Electric does not warrant that the information is fit for any particular purpose, nor does it endorse its use in applications that are critical to the health or life of any human being. Schneider Electric reserves the right to update the information at any time without notice. November 2009 Multi Room Audio Amplifier Installation Instructions 1 Introduction The installation instructions cover a 'standal





Category