Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

Tradewins Furniture RNC95

downloaded: 2File size: 1 mb    Manafacture: Tradewins Furniture  
Category: Fans

have unique ventilation requirements which should be addressed with an isolated ventilation system. Also, the air handler return duct may be used to exhaust from. In this method, the exhaust air is not ducted back to the HRV with "dedicated lines" from bathrooms, kitchens, etc. Instead, the exhaust air is drawn out of the cold air return of the air handler. The air handler blower must be running when the unit is operating for this system to be effective. CAUTION Balancing Dampers and Grilles Bal

Tradewins Furniture RNC5-TPF

downloaded: 0File size: 1 mb    Manafacture: Tradewins Furniture  
Category: Fans

When the outside air temperature drops below 27°F (-3°C), defrost is activated which provides for an automatic defrost cycle. During the automatic defrost cycle the fresh air supply is shut off while the exhaust fan continues to operate. This allows warm inside air to flow through the heat exchanger core melting frost accumulation. After the defrost period, the fresh air supply fan automatically returns to the normal speed and fresh outside air continues to be drawn into the building. Water from

Tradewins Furniture RNC5-TPD

downloaded: 0File size: 1 mb    Manafacture: Tradewins Furniture  
Category: Fans

10 Electrical The HRV unit should be plugged into a standard designated (120VAC) electrical outlet with a ground. The outlet should be serviced by a separate 15 amp/120V circuit. An extension cord should not be used with this appliance. A qualified service technician should make any required electrical connections. Remote Control Connections Prior to connecting remote devices, it is advisable to run self test on the HRV/ERV. Low voltage connections between the remote controls, the dehumidistat,

Tradewins Furniture RNC25

downloaded: 0File size: 770 kb    Manafacture: Tradewins Furniture  
Category: Fans

Balancing damper* EXHAUST AIR from various parts of home. (i.e. bathrooms, kitchens) Cool Air Return Return Air Outdoors 3’ min. recommended NOTES: 1. Furnace blower is required to operate when ventilation from HRV is require. The furnace should be set to run continuously. 2. A minimum separation of 40 inches (1 m) is required between the two direct connections. 3. The exhaust air connection should be upstream of the supply air connection to prevent exhausting any fresh air. 4. Weatherhood arran

Tradewins Furniture RNC20

downloaded: 0File size: 1 mb    Manafacture: Tradewins Furniture  
Category: Fans

* Local code may require greater distances. Intake Weatherhood Requirements • Should be located upstream (if there are prevailing installationonlyasshown. winds) from the exhaust outlet Usingfulllengthhangerstrapsis. recommendedforvibrationcontrol,. • At least 6' (2 m) from the exhaust weather hood * butcanbeshorterifrequired. • At least 6' (2 m) away from dryer vents and air handler exhaust (medium or high efficiency furnaces)* Weatherhood Installation COLLARISSUPPLIEDTO. • A minimum of at leas

Tradewins Furniture RNC15

downloaded: 0File size: 770 kb    Manafacture: Tradewins Furniture  
Category: Fans

The device uses the stale air that is being exhausted to condition the fresh air as it is being brought in. General Required Tools Installation Tools • tin snips • large zip ties • assorted screw drivers • fabric flexible duct • electric drill -class II rated • hammer • mastic tape • wire strippers • alum. foil duct tape • knife • zip ties • caulking gun • 1/2” I.D. drain hose • smoke pencil Balancing Tools • Pitot Tube Balancing Kit [Case, 8 ft. vinyl tubing, Pitot tube, magnehelic gauge (0 -0.

Tradewins Furniture RNC10

downloaded: 2File size: 1 mb    Manafacture: Tradewins Furniture  
Category: Fans

foil duct tape • knife • zip ties • caulking gun • 1/2” I.D. drain hose • smoke pencil Balancing Tools • Pitot Tube Balancing Kit [Case, 8 ft. vinyl tubing, Pitot tube, magnehelic gauge (0 -0.25”), and mounting plate] • Pitot Tube with instructions and Digital Manometer (with resolution of 0 -0.25” -must read to 1/100ths of an inch) Optional Accessories • 20 Minute Fan Timer • Wall Mounted Dehumidistat • Weather hood Kit • Round Diffuser 4” (100mm) 6” (150mm) 8” (200mm) • Kitchen Grille -may be





Category