Login:
Sorted: Name ↑   Downloads   Rate   Size ↑  

Wells WVSW VENTLESS HOOD

downloaded: 0File size: 399 kb    Manafacture: Wells  
Category: Fans

531 p/n 305812 OpManual for Conveyor Hood 6 OPERATING CONTROLS Controls include a lighted POWER SWITCH and an amber REPLACE FILTER indicator light. Press POWER SWITCH to ON anytime conveyor warmer is operating. When power is first turned on, the REPLACE FILTER light will glow. As the fan comes up to speed and air flow is established, the REPLACE FILTER light will go out. If the REPLACE FILTER light does not go out, the filters must be replaced. However, the fan will continue to operate when the

Wells WVOC-G136

downloaded: 0File size: 987 kb    Manafacture: Wells  
Category: Electric Ovens

Replacing both the pre-filter and the filter pack will remedy the situation. Note: replacing the pre-filter, even though not very dirty, will often extend the service life of the more expensive filter pack. Reset the unit by turning the VENTILATOR POWER switch to OFF, then back ON. 6. A failure of incoming electrical power will cause a shut down of the unit. After power is restored, reset the unit by turning the VENTILATOR POWER switch to OFF, then back ON. Fig. 8 Ventilator Indicator and Warnin

Wells WVOC-4HF

downloaded: 0File size: 1 mb    Manafacture: Wells  
Category: Electric Ovens

VENTILATOR OPERATION 1. Press the VENTILATOR POWER switch to ON. The green VENTILATOR POWER light will glow and the blower fan will start. After a short time, if all filters are sensed as being in position and not clogged, the cooking appliance will be energized. The roll warmer is energized at all times. During normal operation, the VENTILATOR POWER light will be the only light glowing on the upper control panel. 2. If the amber CHECK FILTER light glows, one or more filter elements is out of po

Wells WVF-886

downloaded: 1File size: 1 mb    Manafacture: Wells  
Category: Fans

THIS MANUAL MUST BE READ AND UNDERSTOOD BY ALL PERSONS USING OR INSTALLING THIS APPLIANCE. Contact your WELLS DEALER if you have any questions concerning installation, operation or maintenance of this equipment. 503 p/n 304989 Rev. B ECN-12660 M503 040318 cps OPERATION MANUAL WVF-886 SERIES DUAL AUTO-LIFT STS™ FRYER with UNIVERSAL HOOD Includes INSTALLATION USE & CARE Model WVF-886 PRINTED IN UNITED STATES OF AMERICA LIMITED WARRANTY STATEMENT LIMITED WARRANTY STATEMENT Unless otherwise specifie

Wells WPP-6, WPP-10

downloaded: 0File size: 904 kb    Manafacture: Wells  
Category: Other Kitchen Appliances

Wipe lid and stirrer components with a sponge or soft cloth dampened with mild detergent. Rinse by wiping with a sponge or soft cloth dampened with clear water. Allow to air dry. 6. Wipe inside and outside of cabinet, drop door and crumb tray with a sponge or soft cloth dampened with mild detergent. Rinse by wiping with a sponge or soft cloth dampened with clear water. Allow to air dry. NOTES: a. Use care when cleaning doors to prevent scratching. b. Do not wipe heat lamp if it is hot. c. Use ca

Wells WPP-6

downloaded: 1File size: 837 kb    Manafacture: Wells  
Category: Other Kitchen Appliances

Verify that the unit sits firmly ON ALL FOUR LEGS. With a spirit level, check that the appliance is level front-to-back and side-to-side. With the adjustable legs, adjust as required to level the appliance. All four legs must be adjusted to firmly contact the floor in order to prevent tipping. Avoid storing flammable or combustible materials in, on or near the appliance. ASSEMBLY Slide kettle lid over stirrer shaft and lid guide. The handle should be toward the door opening. Slide the lid up unt

Wells WPP-10

downloaded: 0File size: 904 kb    Manafacture: Wells  
Category: Other Kitchen Appliances

appliance. Proper installation, professional operation and consistent maintenance of this appliance will ensure that it gives you the very best performance and a long, economical service life. This manual contains the information needed to properly install this appliance, and to use and care for the appliance in a manner which will ensure its optimum performance. SPECIFICATIONS MODEL VOLTS 1o WATTS AMPS POWER SUPPLY CORD WPP-6 120 VAC 1200 W 10 A NEMA 5-15P WPP-10 120 VAC 1500 W 12.5 A NEMA 5-15

Wells VENTLESS HOOD WVSW

downloaded: 1File size: 486 kb    Manafacture: Wells  
Category: Fans

The technical content of this manual, including any wiring diagrams, schematics, parts breakdown illustrations and/or adjustment procedures, is intended for use by qualified technical personnel. Any procedure which requires the use of tools must be performed by a qualified technician. This manual is considered to be a permanent part of the appliance. This manual and all supplied instructions, diagrams, schematics, parts breakdown illustrations, notices and labels must remain with the appliance i

Wells OC-4TC

downloaded: 0File size: 589 kb    Manafacture: Wells  
Category: Electric Ovens

Fig. 8 Baffle & Rack Support 10. Replace rack supports and oven racks. Leave the door open overnight. Cleaning Instructions continued on page 12. 11 CLEANING INSTRUCTIONS (continued) 11. Clean cooktop: For coil-type elements: a. Rotate elements up. Remove drip pans and elements supports. b. Wash drip pans and element supports with warm water and mild detergent. A plastic scouring pad may be used to remove baked-on food particles. c. Rinse with clean water and allow to air dry before reinstalling

Wells OC-2HG

downloaded: 0File size: 2 mb    Manafacture: Wells  
Category: Electric Ovens

2. The OFFSET MODE can be used to offset the set / displayed temperature from the sensed temperature by as much as ± 35.F, in 5.F increments: a. Rotate the TIME controller until the time digits on the display read "00:00". b. Rotate the TEMP control until the temp digits display between 400. and 500.. c. Press and hold the START TIMER key for five seconds. d. Turn either the TIME or TEMP control until the desired offset is displayed. e. Press the ACTUAL TEMP key to exit. CAUTION ELECTRIC SHOCK H





Category