Login:
Votes - 4, Average rating: 3.5 ( )

User manual ZTE, model MF83M(MobiCom)

Manafacture: ZTE
File size: 731.4 kb
File name:
Language of manual:en
Free link for this manual available at the bottom of the page



manual abstract


End User shall have no right to reject or return the Product, or receive a refund for the Product from ZTE under the above-mentioned situations. • This warranty is End User’s sole remedy and ZTE’s sole liability for defective or nonconforming items, and is in lieu of all other warranties, expressed, implied or statutory, including but not limited to the implied warranties of merchantability and fitness for a particular purpose, unless otherwise required under the mandatory provisions of the law. Limitation of Liability ZTE shall not be liable for any loss of profits or indirect, special, incidental or consequential damages resulting from or arising out of or in connection with using of this product, whether or not ZTE had been advised, knew or should have known of the possibility of such damages, including, but not limited to lost profits, interruption of business, cost of capital, cost of substitute facilities or product, or any downtime cost. Specific Absorption Rate (SAR) Your mobile device is a radio transmitter and receiver. It is designed not to exceed the limits for exposure to radio waves recommended by international guidelines. These guidelines were developed by the independent scientific organization ICNIRP and include safety margins designed to assure the protection of all persons, regardless of age and health. The guidelines use a unit of measurement known as Specific Absorption Rate, or SAR. The SAR limit for mobile devices is 2.0 W/kg and the highest SAR value for this device when tested was 0.819 W/kg. As mobile devices offer a range of functions, they can be used in other positions, such as on the body. As SAR is measured utilizing the device’s highest transmitting power, the actual SAR of this device while operating is typically below that indicated above. This is due to automatic changes to the power level of the device to ensure it only uses the minimum power required to communicate with the network. Troubleshooting Problem Suggested Solution Can not establish the USB connection between your device and PC. • You need to install the software. Run the installation program in path of My Computer > ZTEMODEM. • If the driver of your device is abnormal, please reinstall the software. You need to uninstall the software first. Can not establish the Wi-Fi connection between your device and client. • Make sure the Wi-Fi function is active. • Refresh network list and select the correct SSID. • Check the IP address to make sure your client can obtain an IP address automatically in the Internet protocol (TCP/IP) properties. • Type the correct network key (Wi-Fi password) when you connect to the device. The client connected to the device can not access the Internet. • Make sure your (U)SIM card is available. • Change the location to find a place with good signal. • Check WAN Connection mode setting. • Contact with your service provider and confirm your APN settings. When I use AP Station ...


Reviews



Your review
Your name:
Please, enter two numbers from picture:
capcha





Category