Votes - 2, Average rating: 4.5 ( )

User manual Broan, model 8391 D

Manafacture: Broan
File size: 342.38 kb
File name:
Language of manual:en
Free link for this manual available at the bottom of the page

manual abstract

At normal use the filter should be cleaned every second month (when using the hood 2,5 hours per day, in avarage). The best way to clean the filter is in the dishwasher. Use normal detergent and choose the highest temperature (65. C). Wash the filter separately so that no food parts gets stuck on the filter and later causes bad odours. To reactivate the carbon, the filter should be dried in an oven for 10 minutes with a temperature of maximum 100. C. After approximately three years of use, the carbon filter should be replaced with a new, as the odour reduction capacity will be reduced. • Mounting - Fig. 4 Put the charcoal filter frame in place and fix it with 5 screws. Fit the charcoal filter first from the rear side and fix it frontwards using the two red keys A. • To remove proceed in the reverse order. • Always specify the hood model code number and serial number when ordering replacement filters. This information is shown on the registration plate located on the inside of the unit. • The charcoal filter can be ordered from your local AEG Service Force Centre. Fig. 4 10 Warning • Failure to observe the instructions on cleaning the unit and changing the filters will cause a fire hazard. You are therefore strongly recommended to follow these instructions. • The manufacturer declines all responsibility for any damage to the motor or any fire damage linked to inappropriate maintenance or failure to observe the above safety recommendations. Changing the light bulb • Disconnect the cooker hood from the main supply. 8160 D - 8190 D • Remove the lamp cover. Fig. 5. • Replace the old bulb with a new one of the same type. • Remount the lamp cover. 8260 D - 8290 D - 8360 D - 8390 D - 8361 D - 8391 D • Press (1) the lamp cover (2) and open it. Fig. 6. • Replace the old bulb with a new one of the same type (3). • Close the lamp cover. • If the light does not come on, make sure the bulb has been inserted correctly before contacting your local Service Force Centre. Fig. 6 Fig. 5 What to do if If your appliance fails to work properly please carry out the following checks. Symptom Solution The cooker hood will not start... Check that: The hood is connected to the electricity supply. Check that a fan speed has been selected The cooker hood is not working effectively.. Check that: The fan speed is set high enough for the task. The grease filters are clean. The kitchen is adequately vented to allow the entry of fresh air. If set up for recirculation, check that the charcoal filter is still effective. If set up for extraction, check that the ducting and outlets are not blocked. The cooker hood has switched off during operation... The safety cut-out device has beentripped. Turn off the hob and then wait for the device to reset. If the hood has been installed below the heights indicated in the installation instructions the motor will cut-out frequently which will damage the hood. If after all these checks, the problem persists, contact your local Service Force ...

Other models in this manual:
Fans - 8190 D (342.38 kb)
Fans - 8190 D (342.38 kb)
Fans - 8190 D (342.38 kb)
Fans - 8190 D (342.38 kb)


Your review
Your name:
Please, enter two numbers from picture: